Volkswagen Tiguan Rear Shock Absorber: Specs, Fitment & Common Faults
Genuinely worth confirming first: which rear axle your Tiguan has, since it determines a completely different shock absorber.
Confirmed: Torsion Beam and Multi-Link Need Completely Different Rear Dampers
Genuinely important to establish before ordering: VW Group's MQB-based cars use one of two different rear axle designs depending on engine and trim, and each requires a different rear shock absorber. Standard Tiguans with smaller petrol or diesel engines use a torsion beam (twist beam) rear axle. Higher-output and performance variants use a multi-link rear axle instead — and critically, any 4Motion/4Drive/Quattro (four-wheel-drive) variant mandatorily has multi-link regardless of engine, since a torsion beam leaves no room for a rear differential and driveshaft to pass through. If you're unsure which your car has, look underneath the rear of the car: a single, solid connecting beam is torsion beam; separate arms at each wheel is multi-link.
The Part That Takes Every Bump Before You Feel It
Front suspension tends to get most of the attention since it also handles steering, but the rear shock absorbers wear too — often more subtly, with symptoms that are easy to write off as road noise until they get worse.
OEM Part Numbers
| Torsion beam axle, right | Genuinely a different reference from the left-side shock — VW Group does not sell these as a single interchangeable part for either side |
|---|---|
| Torsion beam axle, left | A genuinely different part number from the right-side shock above |
| Multi-link axle (higher-output/4Motion variants) | Genuinely a different shock from the torsion beam version — confirmed by VW Group's own workshop documentation as requiring a completely different rear damper, not a stiffer version of the same part |
| Adaptive damping shock, where fitted | A genuinely different construction from a non-adaptive shock, with a built-in electrical connector — not interchangeable with a standard shock in either direction, and fitting the wrong type will trigger a persistent dashboard warning |
Cars fitted with a vehicle level sender (part of some self-levelling or headlight self-levelling setups) have an additional linkage arm connected near the shock absorber — genuinely worth noting when removing or replacing the shock, since this arm needs to be disconnected first, but it's a separate part from the shock itself.
What It Does
The rear shock absorber controls how quickly the rear suspension compresses and rebounds over bumps, working independently of the coil spring on most modern rear axles. A worn rear shock lets the back of the car bounce excessively after a bump instead of settling quickly, and can accelerate uneven rear tyre wear if left unaddressed.
Shop for This Part on eBay
Rear Shock Absorber Dust Cover Repair Kit For VW Tiguan & Touran & Golf MK5 MK6
GBP 11.88
FRONT REAR SHOCK ABSORBERS SHOCKS SHOCKERS SET 4 VOLKSWAGEN TIGUAN 2009- 2017
GBP 149.95
REAR SHOCK ABSORBERS SHOCKS X 2 FOR VW TIGUAN (5N) 2.0 TDI 4MOTION 2007-2018
GBP 59.95
For Volkswagen Tiguan 1.4 2.0 2008 - 2017 Rear Shock Absorber Shock Shocker
GBP 31.99
VOLKSWAGEN TIGUAN MK2 AD LEFT OR RIGHT REAR SHOCK ABSORBER 5Q0513425J
GBP 21.90
Volkswagen Tiguan 2008 - 2017 Rear Shock Absorber for 1.4 / 2.0
GBP 27.50
FOR VW TIGUAN (5N) 2007-2018 FRONT REAR SHOCK ABSORBERS SHOCKS SHOCKERS 4 SHOCKS
GBP 139.95
VW TIGUAN (5N) 2.0 TDI 4MOTION 2007-2018 REAR SHOCK ABSORBERS SHOCKS PAIR X 2
GBP 59.95
As an eBay Partner, Car United may earn commission from qualifying purchases shown above. Listings and pricing are pulled live from eBay and may vary.
Warning Signs, DIY Difficulty & Aftermarket Advice
These are the same regardless of make or model — see our full Rear Shock Absorber Guide for symptoms of a worn shock, confirming fitment against your VIN, and OEM vs aftermarket guidance.
More Volkswagen Rear Shock Absorber
The same part, covered across other Volkswagen models.