Car Parts Guide
MASTER CLUTCH CYLINDER Dacia Sandero · PARTS GUIDE

Dacia Sandero Master Clutch Cylinder: Specs, Fitment & Common Faults

Everything — check this before you buy — part numbers, which generations it fits, and the warning signs that it's on its way out.

Dacia Sandero (MK3 2020 ON) clutch master cylinder in the clutch hydraulic circuit, genuine number to confirm via VIN Illustration for editorial purposes
Find Dacia Sandero Master Clutch Cylinder Here!

Opens live listings in a new tab.

OEM Part Number: confirm via VIN

Accuracy note: we weren't able to verify a confident Dacia Sandero master clutch cylinder part number at the time of writing. Please confirm the correct part via a Dacia dealer or parts specialist using your VIN.

Why the Sandero's clutch gets blamed for a hydraulic leak

On the Dacia Sandero, the master and slave clutch cylinders work as a pair, and symptoms of failure look almost identical from the driver's seat — a soft pedal or one that sinks to the floor could be either component. Plenty of owners end up paying for the wrong part first, since there's no way to tell them apart without inspecting the system directly.

Dacia Sandero Master Clutch Cylinder reference plate
Bleeding after a master cylinder change

The Sandero 1.2 from 2013 uses a concentric slave cylinder inside the bell housing, shared with many Renault and Nissan models. Febi Bilstein's fitting sheet for this family says the system must be bled after a new master cylinder goes in, or trapped air will stop the clutch working properly. Bleeding is done at the slave end: the pipe is eased about 5mm out of its connector while the retaining clip is held, and the pedal pressed until fluid runs clear of bubbles. The pipe then clicks back in.

Febi also warns against vacuum or pressure bleeders on this system because they can damage the seals. Ask your garage how they plan to bleed it.

Easy-R cars are different

Sanderos with the Easy-R automated manual have no clutch pedal. An actuator works the clutch, so a pedal-side master cylinder doesn't apply in the same way. Check which gearbox you have before ordering.

Typical cost

ClickMechanic puts the average UK master cylinder replacement at about £200.

Before you buy: part numbers and fitment listed below are a general guide only. Always confirm compatibility using your vehicle's VIN, or check with a Dacia parts specialist, since specifications can vary by trim, model year and market.
What it does

On the Dacia Sandero, the master clutch cylinder converts the pressure from your foot on the clutch pedal into hydraulic force, pushing fluid through a line to the slave cylinder, which in turn disengages the clutch. When it works properly, you don't think about it at all — which is usually a sign it's doing its job.

Part numbers
OEM referenceVaries by engine/transmission — confirm via VIN
Common aftermarket brandsSachs, LUK, Febi Bilstein, ATP

Fitment checks that save a wasted order on the Sandero

This part is not necessarily interchangeable across every Sandero generation or engine — hydraulic clutch systems and bore sizes can differ between petrol and diesel variants, and between manual gearbox revisions. Cross-check the exact part number against your specific vehicle before ordering; a cylinder that looks identical can still be the wrong fit. Whether you're sourcing a replacement master clutch cylinder for your Dacia Sandero from a dealer, specialist, or online marketplace, always check compatibility against your registration or VIN before buying.

Find Dacia Sandero Master Clutch Cylinder Here!

Opens live listings in a new tab.

Leaks, a spongy pedal and how hard the job is

These are the same regardless of make or model — see our full Master Clutch Cylinder Guide for symptoms of failure, how difficult this job is to DIY, and aftermarket advice.