Car Parts Guide
SLAVE CLUTCH CYLINDER Mazda CX-5 · PARTS GUIDE

Mazda CX-5 Slave Clutch Cylinder: Specs, Fitment & Common Faults

The other half of the hydraulic clutch system, and the faults that get mistaken for a failing master cylinder.

Mazda CX-5 (2012-2017) clutch slave cylinder, OEM BP4S-41-920D Illustration for editorial purposes
Find Mazda CX-5 Slave Clutch Cylinder Here!

Opens live listings in a new tab.

Mazda CX-5 Slave Clutch Cylinder reference plate

OEM Part Number: BP4S-41-920D

Accuracy note: confirmed below via a genuine Mazda dealer parts catalogue. This part number has been superseded at least twice (920B → 920C → 920D), so an older reference may still turn up in some listings — the D suffix is the current one. Applies to manual-transmission CX-5s only.
Manual transmission (current reference)Mazda OEM: BP4S-41-920D
Manual transmission (superseded references)BP4S-41-920B / BP4S-41-920C — may still appear on older listings

Why the CX-5's two clutch cylinders get mixed up

On the Mazda CX-5, the master and slave clutch cylinders work as a pair, and symptoms of failure look almost identical from the driver's seat — a soft pedal, a clutch that won't disengage properly — which means diagnosing which one has actually failed usually needs a proper inspection rather than guesswork.

An outside release cylinder

The manual CX-5 uses a release cylinder bolted to the outside of the gearbox, which works the clutch through a fork. That keeps replacement simple compared with cars that have a concentric slave inside the bell housing. The gearbox stays in, and most of the job is undoing the fluid pipe and mounting bolts, then bleeding the system.

What to look for

Pull back the rubber boot around the pushrod. Fluid behind it means the seal is going. Whocanfixmycar lists drips and a falling reservoir level as the usual signs. A pedal that's soft or sinks while the release cylinder stays dry points the other way, at the master cylinder.

Order against the current number

Mazda has superseded this part more than once (see the table above), so older listings may show earlier numbers. Order the current one if possible.

Typical cost

ClickMechanic puts the UK average for a slave cylinder job at about £125, with a range of roughly £60 to £200.

Before you buy: some versions of the CX-5 use an internal slave cylinder built into the gearbox, others use an external unit — these are not interchangeable. Always confirm against your VIN before ordering.
What it does

The slave cylinder receives hydraulic pressure from the master cylinder and uses it to physically push the clutch release mechanism, disengaging the clutch when the pedal is pressed. On many modern cars including several versions of the CX-5, this is built inside the transmission housing as a "concentric slave cylinder," which changes both the part itself and the labour involved in replacing it.

Fitment checks that avoid a wasted gearbox job on the CX-5

Whether the CX-5 uses an internal (concentric) or external slave cylinder depends on the specific generation and transmission — these two designs are not interchangeable, and use entirely different part numbers and replacement procedures. Always confirm which type your specific car uses before ordering. Whether you're sourcing a replacement slave clutch cylinder for your Mazda CX-5 from a dealer, specialist, or online marketplace, always check compatibility against your registration or VIN before buying.

Find Mazda CX-5 Slave Clutch Cylinder Here!

Opens live listings in a new tab.

Common failures and the right replacement

These are the same regardless of make or model — see our full Slave Clutch Cylinder Guide for symptoms of failure, how difficult this job is to DIY, and aftermarket advice.