Car Parts Guide
MASTER CLUTCH CYLINDER Nissan Qashqai · PARTS GUIDE

Nissan Qashqai Master Clutch Cylinder: Specs, Fitment & Common Faults

Everything — check this before you buy — part numbers, which generations it fits, and the warning signs that it's on its way out.

Nissan Qashqai (J11 2014-2021) clutch master cylinder in the clutch hydraulic circuit, genuine number to confirm via VIN Illustration for editorial purposes
Find Nissan Qashqai Master Clutch Cylinder Here!

Opens live listings in a new tab.

OEM Part Number: confirm via VIN

Accuracy note: we weren't able to verify a confident Nissan Qashqai master clutch cylinder part number at the time of writing. Please confirm the correct part via a Nissan dealer or parts specialist using your VIN.

Soft or sticking pedal on the Qashqai? Start at the pedal end

On the Nissan Qashqai, the master and slave clutch cylinders work as a pair, and symptoms of failure look almost identical from the driver's seat — a soft pedal or one that sinks to the floor could be either component. Plenty of owners end up paying for the wrong part first, since there's no way to tell them apart without inspecting the system directly.

Nissan Qashqai Master Clutch Cylinder reference plate
Bleed it the Nissan way

The first Qashqai 1.6 petrol (2006–2014) is on Febi Bilstein's list of cars with a concentric slave cylinder that has a quick-release bleed connector. After a new master cylinder goes in, the system needs bleeding at that connector. The pipe is eased out about 5mm while the clip is held, fluid is pushed through with the pedal until no bubbles appear, then the pipe is clicked back in. Hold the pipe while doing it, because the pressure can push it right off.

Schaeffler's guide to the later 1.5 dCi shows the same connector with two clip positions, one for bleeding and one for normal running. A clip left in the bleed position is a simple cause of a soft pedal after a repair.

No pressure bleeders

Febi says not to use vacuum or pressure bleeding on this system, as it can damage the seals.

Typical cost

ClickMechanic's average Nissan master cylinder job comes to about £264.

Before you buy: part numbers and fitment listed below are a general guide only. Always confirm compatibility using your vehicle's VIN, or check with a Nissan parts specialist, since specifications can vary by trim, model year and market.
What it does

On the Nissan Qashqai, the master clutch cylinder converts the pressure from your foot on the clutch pedal into hydraulic force, pushing fluid through a line to the slave cylinder, which in turn disengages the clutch. When it works properly, you don't think about it at all — which is usually a sign it's doing its job.

Part numbers
OEM referenceVaries by engine/transmission — confirm via VIN
Common aftermarket brandsSachs, LUK, Febi Bilstein, ATP

Getting the order right for the Qashqai's clutch hydraulics

This part is not necessarily interchangeable across every Qashqai generation or engine — hydraulic clutch systems and bore sizes can differ between petrol and diesel variants, and between manual gearbox revisions. Cross-check the exact part number against your specific vehicle before ordering; a cylinder that looks identical can still be the wrong fit. Whether you're sourcing a replacement master clutch cylinder for your Nissan Qashqai from a dealer, specialist, or online marketplace, always check compatibility against your registration or VIN before buying.

Find Nissan Qashqai Master Clutch Cylinder Here!

Opens live listings in a new tab.

Spotting failure, bleeding the system and choosing a brand

These are the same regardless of make or model — see our full Master Clutch Cylinder Guide for symptoms of failure, how difficult this job is to DIY, and aftermarket advice.