Car Parts Guide
SLAVE CLUTCH CYLINDER Suzuki Swift · PARTS GUIDE

Suzuki Swift Slave Clutch Cylinder: Specs, Fitment & Common Faults

The other half of the hydraulic clutch system, and the faults that get mistaken for a failing master cylinder.

Suzuki Swift (2017 ON) clutch slave cylinder, confirm number via VIN Illustration for editorial purposes
Find Suzuki Swift Slave Clutch Cylinder Here!

Opens live listings in a new tab.

Suzuki Swift Slave Clutch Cylinder reference plate

OEM Part Number: confirm via VIN

Accuracy note: we weren't able to verify a confident Suzuki Swift slave clutch cylinder part number at the time of writing. Please confirm the correct part via a Suzuki dealer or parts specialist using your VIN.

Before ordering for the Swift, work out which cylinder it is

On the Suzuki Swift, the master and slave clutch cylinders work as a pair, and symptoms of failure look almost identical from the driver's seat — a soft pedal, a clutch that won't disengage properly — which means diagnosing which one has actually failed usually needs a proper inspection rather than guesswork.

Bleed before you buy

A Swift Sport owner on the Swift Sport Owners Club found it hard to change gear once the car was warm, after a new clutch. Members said the system should be bled first, because warm fluid expands and makes trapped air worse. They suggested suspecting the slave cylinder if bleeding didn't help. The Sport clutch kit listed on our clutch kit page comes with an operating cylinder, so it's sensible to fit it at the same time.

Bleeding it properly

Schaeffler warns that fast or pressure bleeding can push a slave cylinder past its normal travel and damage the seal. Slow, steady pedal strokes with a helper, or gravity bleeding, are safer. Keep the reservoir topped up so no fresh air is drawn in.

Typical cost

ClickMechanic puts the average slave cylinder replacement at about £125, with a range of roughly £60 to £200. Swift engines and years vary, so confirm the part via VIN.

Before you buy: some versions of the Swift use an internal slave cylinder built into the gearbox, others use an external unit — these are not interchangeable. Always confirm against your VIN before ordering.
What it does

The slave cylinder receives hydraulic pressure from the master cylinder and uses it to physically push the clutch release mechanism, disengaging the clutch when the pedal is pressed. On many modern cars including several versions of the Swift, this is built inside the transmission housing as a "concentric slave cylinder," which changes both the part itself and the labour involved in replacing it.

Gearbox and engine variants that change the part on the Swift

Whether the Swift uses an internal (concentric) or external slave cylinder depends on the specific generation and transmission — these two designs are not interchangeable, and use entirely different part numbers and replacement procedures. Always confirm which type your specific car uses before ordering. Whether you're sourcing a replacement slave clutch cylinder for your Suzuki Swift from a dealer, specialist, or online marketplace, always check compatibility against your registration or VIN before buying.

Find Suzuki Swift Slave Clutch Cylinder Here!

Opens live listings in a new tab.

Leaks at the gearbox end and what to replace them with

These are the same regardless of make or model — see our full Slave Clutch Cylinder Guide for symptoms of failure, how difficult this job is to DIY, and aftermarket advice.