Citroen Berlingo Brake Pads: Specs, Fitment & Wear Symptoms
On the Berlingo, leaving the ignition on while changing rear pads can trigger a genuine EPB fault — plus a key generational distinction.
Opens live listings in a new tab.
OEM Part Number: confirm via VIN — front pads (aftermarket) Brembo P 61 083 / Bosch 0 986 494 235
| Front brake pads (aftermarket) | Brembo P 61 083 (155 x 58-65 x 18-19 mm, wear contact excluded, ATE/Teves/Continental system); Bosch 0 986 494 235 (155.2 x 57.7-64.7 x 18.3-18.8 mm, wear sensor not stated); ATE 13.0460-7229.2 (155.1 x 58.3-64.7 x 18.5 mm, no wear contact, ATE/Teves/Continental system); Ferodo FDB1971 (155.2 x 57.8-64.5 x 18 mm, not prepared for a sensor, ATE/Teves/Continental system, fitting position not stated); TRW GDB1690 (155.2 x 57.7-64.7 x 18.3-18.8 mm, not prepared for a sensor, ATE restriction, fitting position not stated); Ridex 402B0181 (155.2 x 57.7-64.7 x 18.3-18.8 mm, no wear sensor) |
|---|---|
| Pad sizes & variants | The common front pad is about 155 x 58-65 x 18-19 mm (ATE/Teves system), shared by all the brands above and febi 16713 and Valeo 301997. A much smaller 137 x 49 x 19 mm pad (Valeo 301464, Bosch system) is also listed as a front set. |
| Genuine (OE) numbers quoted | None quoted in catalogue listings — order genuine pads against your VIN |
| Fitment notes | Pads carry no wear sensor, which suits a car with no pad-wear warning; Brembo P 61 084 and Delphi LP565 are rear-sized and not front sets. No Pagid, Textar, Mintex or Delphi front sets. |
Ignition off before rear pad work on the Berlingo
If your car has an electronic parking brake, this is worth taking seriously before starting a rear pad job: leaving the ignition switched on while releasing the handbrake and changing the pads has been documented to cause a genuine EPB fault, with real confirmed fault codes (C156C-92 and C1561-00, relating to the actuator sensors) appearing afterward. Always switch the ignition fully off once the parking brake is released and before starting any work on the rear calipers, rather than leaving it on for convenience.
If the EPB has stopped engaging or releasing after pad work, a useful first troubleshooting step before assuming a deeper fault: turn the ignition on and leave it for around 5 seconds, then activate the parking brake switch to apply it and hold for a further 5 seconds. If this doesn't restore normal function, the fault is likely to need proper diagnostic equipment to investigate further.
One of the few truly universal partsEvery version of the Berlingo uses brake pads that wear down through normal use — the only real variable is how quickly, which depends on engine, trim, and (where fitted) whether the car has any form of regenerative braking to ease the load.
Watch: replacing themB9 era front discs and pads
What happens at the pads when the Berlingo brakes
Brake pads clamp against the discs to convert the car's momentum into heat, slowing it down. On any version of the Berlingo with hybrid assistance or regenerative braking, this system handles a meaningful share of everyday slowing, which can extend pad life compared with a purely petrol or diesel equivalent.
Sizes of pad fitted across the Berlingo range
| B9 generation, front pad (282.6mm, most 1.6 HDi variants) | Confirm exact fitment via VIN — pad size on this model varies by engine and trim, not just by generation. |
|---|---|
| B9 generation, rear pad | Confirm exact fitment via VIN — pad size on this model varies by engine and trim, not just by generation. |
| Current generation, higher-power variants, front pads | a different, larger pad to match the 304mm disc/caliper on this higher tier — not interchangeable with the standard-tier pad on the same axle. |
| Older/lower-power variants, front pads | a different, larger pad to match the 266mm disc/caliper on this higher tier — not interchangeable with the standard-tier pad on the same axle. |
Opens live listings in a new tab.
These are the same regardless of make or model — see our full Brake Pads Guide for warning signs to watch for, confirming fitment against your VIN, and R90-certified aftermarket brands worth trusting.
The same part on other modelsThe same part, covered across other Citroen models.