Car Parts Guide
REAR SPRINGS Fiat 500 · PARTS GUIDE

Fiat 500 Rear Springs: Specs, Fitment & Common Faults

Worth confirming first: drivetrain and left/right side both affect which rear spring fits.

Fiat 500 (2020 ON) rear coil spring, free length 264 mm, aftermarket Sachs 992321 Illustration for editorial purposes
Find Fiat 500 Rear Springs Here!

Opens live listings in a new tab.

OEM Part Number: confirm via VIN

Aftermarket coils: Sachs 992321 / Suplex 09282

Accuracy note: Covers the Fiat 500 (500e 2020- (if absent use 500 2007-)) as listed in the UK aftermarket catalogues. Rear coil springs are sold as a pair for the axle and should be replaced as a pair, because a new spring beside a tired one leaves the car sitting unevenly. The right spring depends on the engine and gearbox, the suspension type (standard, sport or heavy-duty) and, on some cars, the body style. The references below are UK aftermarket catalogue listings for this generation, labelled by brand with the fitment details the catalogue gives; carmakers rarely publish the genuine number against these, so match a genuine spring against your VIN if you want a guaranteed fit. Rear springs are sold in left/right pairs matched to a specific rate marking — confirm the marking on your existing spring rather than assuming from trim alone.
Rear coil springs (aftermarket)Sachs 992321 (standard, 264 mm); Suplex 09282 (standard, 264 mm); Eibach R23226 (standard, 273 mm)
Genuine (OE) numbers quotedNone quoted in the catalogue listings — the genuine spring varies by engine, suspension type and body style, so order it against your VIN
Front-wheel drive, standard ratea different spring from the AWD version below — confirm drivetrain and side before ordering
AWDA different spring from the front-wheel-drive version, reflecting the different rear axle layout

Always replace Fiat 500 rear springs in pairs — a single new spring paired with an old, sagged one on the other side creates an uneven ride height and handling bias.

A sagging corner, then a snap: how the 500's springs give out

On the Fiat 500, a rear spring often sags gradually for months without an obvious symptom beyond a slightly lower ride height, then fails suddenly at the coil's end with an audible clunk — worth bearing in mind if you notice one rear corner sitting lower than the other.

Before you buy: drivetrain, trim, and left/right side all affect spring rate and fitment. Always confirm against your VIN before ordering.
Fiat 500 Rear Springs reference plate

How the coils hold up the back of the 500

The Fiat 500's rear coil spring supports the weight of the car's rear end and absorbs the initial impact of a bump, working alongside the shock absorber rather than replacing its function. A sagged or broken spring lowers ride height, can affect headlight aim, and in severe cases is an MOT failure item.

Find Fiat 500 Rear Springs Here!

Opens live listings in a new tab.

Spotting failure and choosing replacement coils

These are the same regardless of make or model — see our full Rear Springs Guide for symptoms of a failing spring, confirming fitment against your VIN, and OEM vs aftermarket guidance.

The same part on other models

The same part, covered across other Fiat models.