Fiat 500X Rear Bumper: Fitment, Sensors & Common Damage
On the 500X, directly splicing towbar wiring into the car's own circuit can trigger the CAN-bus system to disable it entirely.
Opens live listings in a new tab.
OEM Part Number: confirm via VIN
Rear bumper sections (aftermarket) Prasco FT0601051
| Rear bumper covers (aftermarket) | No complete aftermarket cover listed for this generation — order genuine against your VIN or use a used panel in your colour |
|---|---|
| Lower sections, corners & trims | Prasco FT0601051 (Rear, Colour: black, Section: Upper section, Smooth); Prasco FT0601061 (Rear, Colour: black, Section: Lower Section); Prasco FT0601071 (Rear, Colour: black, Section: Lower Section, Grained, with holes for trim/protective strip, with holes for park assist) |
| Genuine (OE) numbers quoted | None quoted in the catalogue listings — the genuine cover varies by body style, parking sensors and tow bar, so order it against your VIN |
| Fitment notes | Match body style, facelift date and the holes for parking sensors or exhaust trims; covers come primed and need painting to your paint code before fitting. |
Splicing towbar wiring into the 500X: don't
If you're fitting towbar electrics yourself, this is important: the proper OEM approach uses individual signal wires for each function to avoid the car's CAN-bus system detecting an electrical overload. Directly splicing a trailer light circuit into the car's own wiring risks the car's own computer disabling that circuit entirely, rather than the trailer simply failing to work.
Note too that reversing sensors are generally unaffected by towbar fitting, but the towball cover, if positioned even slightly askew, can trigger a false sensor warning.
Towbar wiring, sensors and the 500X's back panel
The Fiat 500X's rear bumper is rarely just a bumper — parking sensors, a reversing camera housing, and sometimes exhaust trim finishers are commonly built into it, so even minor kerb damage can turn a simple swap into a bigger job.
Watch: replacing itThe sequence is much the same on this generation: wheel-arch liner screws, the fixings along the boot aperture and under the lower edge, then unclip each corner from the wing and unplug any sensor loom before the cover comes away.
How the 500X's tail absorbs a low-speed knock
Beyond absorbing minor impacts, the rear bumper on higher trims of the 500X often houses parking sensors, a reversing camera, and sometimes integrated exhaust finishers. A bumper that looks compatible can still be missing the correct cutouts or wiring provisions for your specific trim's equipment.
Generations and Colour| Standard trims | Bossa Nova White, Rock 'n' Roll Blue, Colosseum Grey, Passion Red |
|---|---|
| Connect trim | Body-coloured door mirrors and 17-inch alloys distinguish this trim from lower grades |
Opens live listings in a new tab.
These are the same regardless of make or model — see our full Rear Bumper Guide for common damage types, confirming fitment (body style and sensor equipment matter here), and OEM vs aftermarket guidance.
The same part on other modelsThe same part, covered across other Fiat models.