Ford Focus Mk3 Alloy Wheels: Sizes, Fitment & Buying Advice
What size you actually need, what to check before buying used, and when refurbishment beats replacement.
Opens live listings in a new tab.
OEM Part Number: confirm via VIN
How the wheels shape the look of the Focus Mk3
Few upgrades change how a car looks as much as a wheel swap, which is exactly why this is one of the most heavily searched, most heavily counterfeited, and most commonly mismatched parts categories out there. Getting the size and offset right matters far more than most buyers realise.
Check for pressure sensors before buying a second setOn the Ford Owners Club, owners of the facelifted Mk3 (2014 on) say their cars use pressure sensors built into the tyre valves, where the earlier Mk2.5 judged pressure from wheel speed. If your Focus has sensors and you buy a set of winter or second-hand wheels without them, the warning light will stay on. One owner paid about £10 a wheel for plain valves fitted and balanced, and another suggested new sensors at about €200 for four. Members also warned that switching the system off with diagnostic software takes the car outside its type approval and could cause MOT and insurance trouble.
Changing sizeFord Owners Club members discussing the later Mk4 made two points that apply to any Focus. A different wheel size counts as a modification, so tell your insurer. And if the rolling circumference changes, the speedometer can read slightly out, so stick to a tyre size listed for your trim.
Refurbish or replaceCheckatrade's guide puts a single refurbished wheel (up to 20 inches) at about £80 and a set of four at about £300. Diamond-cut wheels cost more, at around £115 each, because they go back on a lathe. FixMyCar data from August 2025 gives £227 as the average mobile alloy repair on a Ford. A cracked or bent wheel is a safety matter, so have it checked by a specialist rather than just repainted.
Rim sizes and fitments across the Focus Mk3 range
| Standard trims | 16" or 17" |
|---|---|
| ST-Line / sportier trims | 17" or 18" |
| ST performance trim | 18x8 with 55mm offset (ET55) as standard fitment |
| Bolt pattern (PCD) | 5x108 — consistent across the whole Mk3 range, including ST and RS |
Opens live listings in a new tab.
Kerb damage on the Focus: refurbish or replace
These are the same regardless of make or model — see our full Alloy Wheels Guide for common damage types, confirming bolt pattern and offset against your VIN, and whether refurbishing or replacing is the right call.
The same part on other Ford modelsOwn a different Ford? Alloy wheel sizing, PCD and common damage patterns are broadly similar across the range, but always confirm the specifics for your exact model.
The same part on other modelsThe same part, covered across other Ford models.