Jaguar E-Pace Rear Bumper: Fitment, Sensors & Common Damage
On the E-Pace, a factory cable tie at the boot hinge on related models is fitted too tightly, and repeated flexing eventually breaks a wire inside.
Opens live listings in a new tab.
OEM Part Number: confirm via VIN
No aftermarket cover listed for this generation
| Rear bumper covers (aftermarket) | No complete aftermarket cover listed for this generation — order genuine against your VIN or use a used panel in your colour |
|---|---|
| Lower sections, corners & trims | None listed separately |
| Genuine (OE) numbers quoted | None quoted in the catalogue listings — the genuine cover varies by body style, parking sensors and tow bar, so order it against your VIN |
| Fitment notes | Match body style, facelift date and the holes for parking sensors or exhaust trims; covers come primed and need painting to your paint code before fitting. |
Sensors, cameras and brackets: what sits in the E-Pace's tail
The Jaguar E-Pace's rear bumper is rarely just a bumper — parking sensors, a reversing camera housing, and sometimes exhaust trim finishers are commonly built into it, so even minor kerb damage can turn a simple swap into a bigger job.
The job the back panel does on the E-Pace
Beyond absorbing minor impacts, the rear bumper on higher trims of the E-Pace often houses parking sensors, a reversing camera, and sometimes integrated exhaust finishers. A bumper that looks compatible can still be missing the correct cutouts or wiring provisions for your specific trim's equipment.
Watch: replacing itThe sequence is much the same on this generation: wheel-arch liner screws, the fixings along the boot aperture and under the lower edge, then unclip each corner from the wing and unplug any sensor loom before the cover comes away.
| All generations | Fuji White (named after Mount Fuji), Narvik Black, Firenze Red, Caesium Blue |
|---|
Opens live listings in a new tab.
A documented cause of an intermittent camera
If the reversing camera has stopped working intermittently, a well-documented cause on related Jaguar models is a factory-fitted cable tie at the boot hinge that's fitted too tightly, with repeated flexing every time the boot opens and closes gradually breaking a wire inside. This exact fault has reportedly received a recall in the US, but not in the UK.
Also, on related models, all the wiring needed to retrofit a genuine reversing camera has, in documented cases, already been present in the car from the factory, simply hidden from view.
Common damage, DIY difficulty and aftermarket adviceThese are the same regardless of make or model — see our full Rear Bumper Guide for common damage types, confirming fitment (body style and sensor equipment matter here), and OEM vs aftermarket guidance.
The same part on other modelsThe same part, covered across other Jaguar models.