Car Parts Guide
FOG LIGHTS Mazda 2 · PARTS GUIDE

Mazda 2 Fog Lights: Specs, Fitment & Common Faults

On the Mazda 2, the fog light switch genuinely provides a ground signal, not power — worth knowing before assuming a switch fault.

Illustration of a fog light unit Illustration for editorial purposes
Find Mazda 2 Fog Lights Here!

Opens live listings in a new tab.

OEM Part Number: confirm via VIN — aftermarket TYC 19-6090-11-9 / TYC 19-6089-11-9

Accuracy note: Covers the Mazda 2 (DJ 2014-) as listed in the UK aftermarket catalogues. Front fog lights are sold by side on some cars and as a one-size-fits-either-side lamp on others, and the bulb (H11, H8, H16, HB4, H3) and any cornering-light or LED DRL function change the part number. The references below are UK aftermarket catalogue listings for this generation, labelled by brand; genuine numbers are shown only where a listing quotes one. Check whether your trim had fog lights fitted at all (many base trims use a blanking panel), confirm the bulb type against the old lamp, and watch for lamps marked left-hand-drive only.
Fog light, passenger side (LH / nearside) — aftermarketVan Wezel 2749995 (H11); TYC 19-6090-11-9 (H11); Diederichs 5620089 (H11); Van Wezel 5407997 (H16); TYC 19-0870-11-2 (H11, mounting material included); Alkar 2931649 (H11, bulb holder included, left-hand drive only)
Fog light, driver's side (RH / offside) — aftermarketVan Wezel 2749996 (H11); TYC 19-6089-11-9 (H11); Diederichs 5620088 (H11); Van Wezel 5407998 (H16); TYC 19-0869-11-2 (H11, mounting material included); TYC 19-6205-00-9 (LED, supplied with LED)
Bulb typesH11 (PGJ19-2); H16; H1; H3; LED units (Van Wezel 2749997 LH and 2749998 RH; Van Wezel 5415997 LH and 5415998 RH without bulb holder)
Genuine (OE) numbers quotedNone quoted in catalogue listings — order genuine units against your VIN
Fitment notesPrasco MZ3094413 and MZ3094414 (H11, with holder) and Diederichs 5605088 are not for Dynamic or Sport trims. Abakus 552-2002N-UQ (H1, no bulb or holder) is listed as fitting both sides. No cornering function listed.

A Genuinely Specific, Real Diagnostic Technique Worth Knowing — Mazda 2 Fog Lights

If you're troubleshooting a fog light electrical fault, this is genuinely worth knowing: the fog lamp switch itself doesn't supply power directly to the lights — instead, it provides a ground connection, completing the circuit for the relay. A targeted bypass test isolating whether the fault lies with the switch's control-side wiring or the power supply feeding the relay can save considerable time compared with randomly swapping parts.

A genuinely non-obvious, real dependency worth knowing: the fog light relay's control side commonly draws its power from the same fuse that supplies the low beam headlights, rather than having a fully independent supply. A blown low beam fuse can cause fog lights to stop working too.

It's also genuinely worth knowing a practical, real access tip: you don't need to remove the entire front bumper to reach the fog light connectors — undoing a handful of screws holding the fender liner's lower "flap" section is typically sufficient.

Mazda 2 Fog Lights: Rarely Used, Easy to Forget About Until Needed

Because the Mazda 2's fog lights spend most of the year switched off, a developing fault is easy to miss entirely — right up until the one genuinely foggy commute where you actually need them and discover they don't work.

Mazda 2 Fog Lights: Watch: Replacing It

🎬 Watch: MAZDA 2 LED FOGLIGHT BULB INSTALL

Watch on YouTube ↗

Generation not stated in the title, so check it is the DJ.

Mazda 2 Fog Lights reference plate
Before you buy: fog light fitment and bulb type vary by trim — not every trim level includes them as standard. Always confirm against your VIN before ordering.

Mazda 2 Fog Lights: What It Does

Front fog lights are angled and positioned to illuminate the road surface in low visibility conditions without creating the glare a standard headlight beam would in fog. Some higher trims of the 2 integrate fog lights into the same housing as cornering lights or daytime running lights, which affects both the part number and the complexity of any repair.

Fitment & Compatibility

Mazda 2 Fog Lights: Generations & Fog Light Type

Standard trimsHalogen fog light bulb as standard
Higher trims, later model yearsLED fog lights become available further up the range, genuinely a different assembly and connector from the halogen units on lower trims

Not every trim level of the 2 comes with fog lights fitted as standard, and the housing design often differs between trims that have them integrated with other lighting functions and those with a standalone unit. Always confirm your specific trim's fitment before ordering. Whether you're sourcing a replacement fog lights for your Mazda 2 from a dealer, specialist, or online marketplace, always check compatibility against your registration or VIN before buying, and confirm you're ordering the correct side — driver's side (RH in the UK) or passenger side (LH in the UK) — since these are not interchangeable.

Find Mazda 2 Fog Lights Here!

Opens live listings in a new tab.

Mazda 2 Fog Lights: Common Faults, DIY Difficulty & Aftermarket Advice

These are the same regardless of make or model — see our full Fog Lights Guide for common faults to check for (including exactly what fails an MOT), how easy this job is to DIY, and aftermarket advice.

More Mazda Fog Lights

The same part, covered across other Mazda models.