Car Parts Guide
FOG LIGHTS Mazda CX-3 · PARTS GUIDE

Mazda CX-3 Fog Lights: Specs, Fitment & Common Faults

On the CX-3, the fog light switch genuinely provides a ground signal, not power — worth knowing before assuming a switch fault.

Illustration of a fog light unit Illustration for editorial purposes
Find Mazda CX-3 Fog Lights Here!

Opens live listings in a new tab.

OEM Part Number: confirm via VIN — aftermarket TYC 19-5785-11-2

Accuracy note: Covers the Mazda CX-3 (2015-) as listed in the UK aftermarket catalogues. Front fog lights are sold by side on some cars and as a one-size-fits-either-side lamp on others, and the bulb (H11, H8, H16, HB4, H3) and any cornering-light or LED DRL function change the part number. The references below are UK aftermarket catalogue listings for this generation, labelled by brand; genuine numbers are shown only where a listing quotes one. Check whether your trim had fog lights fitted at all (many base trims use a blanking panel), confirm the bulb type against the old lamp, and watch for lamps marked left-hand-drive only.
Fog light, passenger side (LH / nearside) — aftermarketValeo Fogstar 088358 (H11, bulb included, round 90 mm, fits either side); TYC 19-5785-11-2 (H11, fits either side); TYC 19-0868-11-2 (H11, mounting material included); Abakus 216-2011L-UQD (H11, no bulb or holder); Van Wezel 2786995 (LED, W2.1x9.5d socket); Alkar 2921906 (LED, bulb holder included)
Fog light, driver's side (RH / offside) — aftermarketValeo Fogstar 088358 and TYC 19-5785-11-2 (fit either side, see LH); Abakus 216-2011R-UQD (H11, no bulb or holder); Van Wezel 2786996 (LED, W2.1x9.5d socket); Alkar 2922906 (LED, bulb holder included); TYC 19-6205-00-9 (LED, supplied with LED)
Bulb typesH11 (PGJ19-2); LED units; H3 and H1 (Abakus options for other fitments)
Genuine (OE) numbers quotedNone quoted in catalogue listings — order genuine units against your VIN
Fitment notesBoth halogen H11 and LED lamps are listed, so confirm the type fitted. No cornering function listed.

A Genuinely Specific, Real Diagnostic Technique Worth Knowing — Mazda CX-3 Fog Lights

If you're troubleshooting a fog light electrical fault, this is genuinely worth knowing: the fog lamp switch itself doesn't supply power directly to the lights — instead, it provides a ground connection, completing the circuit for the relay. A targeted bypass test isolating whether the fault lies with the switch's control-side wiring or the power supply feeding the relay can save considerable time compared with randomly swapping parts.

A genuinely non-obvious, real dependency worth knowing: the fog light relay's control side commonly draws its power from the same fuse that supplies the low beam headlights, rather than having a fully independent supply. A blown low beam fuse can cause fog lights to stop working too.

It's also genuinely worth knowing a practical, real access tip: you don't need to remove the entire front bumper to reach the fog light connectors — undoing a handful of screws holding the fender liner's lower "flap" section is typically sufficient.

Mazda CX-3 Fog Lights: Rarely Used, Easy to Forget About Until Needed

The Mazda CX-3's fog lights sit idle for the vast majority of owners most of the year, which is exactly why a fault can go undetected for months — surfacing only on the one properly foggy morning when it matters most.

Mazda CX-3 Fog Lights: Watch: Replacing It

🎬 Watch: MAZDA 2 LED FOGLIGHT BULB INSTALL (sister (Mazda 2))

Watch on YouTube ↗

Weak: no CX-3 fog video found; CX-3 is built on the Mazda 2 platform.

Mazda CX-3 Fog Lights reference plate
Before you buy: fog light fitment and bulb type vary by trim — not every trim level includes them as standard. Always confirm against your VIN before ordering.

Mazda CX-3 Fog Lights: What It Does

Front fog lights are angled and positioned to illuminate the road surface in low visibility conditions without creating the glare a standard headlight beam would in fog. Some higher trims of the CX-3 integrate fog lights into the same housing as cornering lights or daytime running lights, which affects both the part number and the complexity of any repair.

Fitment & Compatibility

Mazda CX-3 Fog Lights: Generations & Fog Light Type

Standard trimsHalogen fog light bulb as standard
Higher trims, later model yearsLED fog lights become available further up the range, genuinely a different assembly and connector from the halogen units on lower trims

Not every trim level of the CX-3 comes with fog lights fitted as standard, and the housing design often differs between trims that have them integrated with other lighting functions and those with a standalone unit. Always confirm your specific trim's fitment before ordering. Whether you're sourcing a replacement fog lights for your Mazda CX-3 from a dealer, specialist, or online marketplace, always check compatibility against your registration or VIN before buying, and confirm you're ordering the correct side — driver's side (RH in the UK) or passenger side (LH in the UK) — since these are not interchangeable.

Find Mazda CX-3 Fog Lights Here!

Opens live listings in a new tab.

Mazda CX-3 Fog Lights: Common Faults, DIY Difficulty & Aftermarket Advice

These are the same regardless of make or model — see our full Fog Lights Guide for common faults to check for (including exactly what fails an MOT), how easy this job is to DIY, and aftermarket advice.

More Mazda Fog Lights

The same part, covered across other Mazda models.