Car Parts Guide
BRAKE PADS Volkswagen Caddy · PARTS GUIDE

Volkswagen Caddy Brake Pads: Specs, Fitment & Wear Symptoms

If your Caddy has an electronic parking brake, DIY rear pad replacement without the right tool can leave the car immobilised.

Volkswagen Caddy (2010-2020) brake pads, aftermarket Brembo P 85 147 Illustration for editorial purposes
Find Volkswagen Caddy Brake Pads Here!

Opens live listings in a new tab.

OEM Part Number: confirm via VIN — front pads (aftermarket) Brembo P 85 147 / Bosch 0 986 494 660

Accuracy note: Covers the Volkswagen Caddy (2K 2010-2020) as listed in the UK aftermarket catalogues. Front brake pads are sold by caliper system (ATE / Teves, TRW / Lucas, Bosch, Akebono, Brembo etc.) and by pad size, and one model usually has two or three pad sizes depending on engine, brake size and trim — a wrong size will not fit the caliper. The references below are UK aftermarket catalogue listings for this generation, labelled by brand with their width x height x thickness in mm; genuine numbers are shown only where a listing quotes one. Measure the old pad or check the caliper system against your VIN before ordering, and fit a new wear sensor where the set is only 'prepared for' one.
Front brake pads (aftermarket)Brembo P 85 147 (160 x 65 x 20 mm, wear sensor prepared but not included, TRW/Lucas/Girling system, WVA 25683, caliper screws and anti-squeak plate supplied); Bosch 0 986 494 660 (160.2 x 64.5 x 20.4 mm, integrated wear sensor, WVA 25086, low-metallic, bolts included); TRW GDB1956 (160.2 x 64.5 x 20.4 mm, wear contact included 170 mm, TRW/Lucas/Girling system, E9 90R-02A0112/3374); ATE 13.0460-2785.2 (160.0 x 64.5 x 20.4 mm, wear contact included 171.5 mm, TRW/Lucas/Girling system, E1 90R-02A0335/0074, 4 bolts, accessory kit 24.8190-0065.2); ATE 13.0470-2785.2 ceramic (160.0 x 64.5 x 20.4 mm, wear contact included 171.5 mm, TRW/Lucas/Girling system, rated to 225 kW); Ferodo FDB4433 (height 64.6 x thickness 20.2 mm, wear contact included, TRW/Lucas/Girling system, WVA 25086 and 25684, caliper screws included); Delphi LP3584 (160.2 x 64.5 x 20 mm, prepared for sensor but contact not included, TRW/Lucas/Girling system, WVA 25086 and 25683).
Pad sizes & variantsOne front size only, roughly 160 x 65 x 20 mm (WVA 25086 / 25683 / 25684 / 25686), fitting the TRW/Lucas/Girling caliper. No engine-specific or larger-brake variants are listed.
Genuine (OE) numbers quotedNone quoted in catalogue listings — order genuine pads against your VIN
Fitment notesEvery front set fits the TRW/Lucas/Girling caliper and all are either supplied with or prepared for a single wear-warning contact; the Brembo P 85 147 and Delphi LP3584 need the contact bought separately, while the Bosch, TRW, ATE and Ferodo sets have it included. No engine or chassis-number restrictions apply.

How the electronic handbrake complicates rear pads on the Caddy

Some models in this range use an Electronic Parking Brake (EPB) on the rear, which changes the pad replacement job — the caliper houses a small motor that must be put into a "service mode" using a diagnostic scan tool (VCDS or OBDeleven) before the piston can be safely retracted. Skipping this and simply forcing the piston back with a standard caliper tool risks serious damage: documented cases include a torn piston seal and the parking brake becoming permanently stuck engaged, leaving the car unable to move at all without recovery.

If you don't have access to VCDS or OBDeleven: many independent garages have the correct tooling for a modest fee. If the EPB does become stuck after a mistake, disconnecting the battery overnight and removing the relevant parking brake fuse has resolved this for some owners, based on real accounts — though a stuck motor may still need proper diagnostic intervention. Always confirm whether your specific car has EPB or a conventional cable handbrake before starting the job.
One of the few truly universal parts

Every version of the Caddy uses brake pads that wear down through normal use — the only real variable is how quickly, which depends on engine, trim, and (where fitted) whether the car has any form of regenerative braking to ease the load.

Before you buy: pad size and compound vary by engine and trim. Always confirm against your VIN before ordering.
Watch: replacing them

🎬 Watch: How to replace the Front Discs and Pads on a 2016 VW Caddy 2k (2015-2020)

Watch on YouTube ↗

2K facelift era, discs and pads.

Volkswagen Caddy Brake Pads reference plate

What each pad set does

Brake pads clamp against the discs to convert the car's momentum into heat, slowing it down. On any version of the Caddy with hybrid assistance or regenerative braking, this system handles a meaningful share of everyday slowing, which can extend pad life compared with a purely petrol or diesel equivalent.

The pad sizes found

PR code 1ZA (confirmed via UK VW forum)Sized to match the 312mm disc/caliper on this tier. Pad size scales with engine output and trim on this model, not just the disc diameter — always confirm the exact pad against your VIN rather than assuming from generation alone.
Front brake pads and pads, alternative genuine cross-referenceSized to match the 256mm disc/caliper on this tier. Pad size scales with engine output and trim on this model, not just the disc diameter — always confirm the exact pad against your VIN rather than assuming from generation alone.
2.0 TDI (140bhp) Mk3, rear padsSized to match the 272mm disc/caliper on this tier. Pad size scales with engine output and trim on this model, not just the disc diameter — always confirm the exact pad against your VIN rather than assuming from generation alone.
Find Volkswagen Caddy Brake Pads Here!

Opens live listings in a new tab.

Wear symptoms, DIY difficulty and aftermarket advice

These are the same regardless of make or model — see our full Brake Pads Guide for warning signs to watch for, confirming fitment against your VIN, and R90-certified aftermarket brands worth trusting.

The same part on other models

The same part, covered across other Volkswagen models.