Citroen C4 Picasso Rear Bumper: Fitment, Sensors & Common Damage
Connector pins can oxidise from ordinary moisture, resolved just by disconnecting and reconnecting — plus a real cost-saving towbar fitting tip.
Opens live listings in a new tab.
OEM Part Number: confirm via VIN
Aftermarket covers: Van Wezel 0979546 / Van Wezel 0979545
| Rear bumper covers (aftermarket) | Van Wezel 0979546 (Rear, primed, with holes for park assist); Van Wezel 0979545 (Rear, primed, with holes for parking sensors); Blic 5506-00-0538951P (Rear); Blic 5506-00-0538953P (Rear, with holes for parking sensors); Blic 5506-00-0538952P (Rear, with holes for parking sensors) |
|---|---|
| Lower sections, corners & trims | None listed separately |
| Genuine (OE) numbers quoted | None quoted in the catalogue listings — the genuine cover varies by body style, parking sensors and tow bar, so order it against your VIN |
| Fitment notes | Match body style, facelift date and the holes for parking sensors or exhaust trims; covers come primed and need painting to your paint code before fitting. |
Cleaning the camera connector on the C4 Picasso
If your reversing camera works intermittently or shows no picture at all, the connector behind the camera can develop a thin layer of oxidisation on its pins simply from ordinary ambient moisture over time, even though the area is technically protected from direct water ingress — it doesn't need to be a leak, just normal humidity working on connectors that aren't fully hermetically sealed. Disconnecting the connector and reconnecting it firmly is often enough to clean the pins through simple contact friction and restore a reliable connection, resolving the fault entirely without needing any parts replaced.
The trailer control module does more than simply provide power to the socket — it interfaces with the car's stability system to disable rear parking sensors and apply a specific towing driving programme when a trailer is detected connected. This is a reason to insist on a proper wiring kit rather than a basic splice, since a bypass that skips this module means missing out on this automatic sensor disabling and stability adjustment.
Towbar wiring, sensors and the C4 Picasso's back panel
The Citroen C4 Picasso's rear bumper is rarely just a bumper — parking sensors, a reversing camera housing, and sometimes exhaust trim finishers are commonly built into it, so even minor kerb damage can turn a simple swap into a bigger job.
Watch: replacing itThe sequence is much the same on this generation: wheel-arch liner screws, the fixings along the boot aperture and under the lower edge, then unclip each corner from the wing and unplug any sensor loom before the cover comes away.
How the C4 Picasso's tail absorbs a low-speed knock
Beyond absorbing minor impacts, the rear bumper on higher trims of the C4 Picasso often houses parking sensors, a reversing camera, and sometimes integrated exhaust finishers. A bumper that looks compatible can still be missing the correct cutouts or wiring provisions for your specific trim's equipment.
Generations, Derivatives and Colour| Standard trims | Polar White (no-cost), Soft Sand, Arctic Steel, Perla Nera black — despite the name meaning "black pearl," Perla Nera is a standard metallic finish, not a pearlescent one |
|---|---|
| Premium metallic | Elixir Red is the most expensive, premium-tier paint offered and was used on much of the model's promotional material |
| Colour Packs | Change the front foglight surrounds and Airbump highlights independently of the body colour — availability depends on spec and powertrain, so confirm before assuming any combination is possible |
Opens live listings in a new tab.
These are the same regardless of make or model — see our full Rear Bumper Guide for common damage types, confirming fitment (body style and sensor equipment matter here), and OEM vs aftermarket guidance.
The same part on other modelsThe same part, covered across other Citroen models.