Car Parts Guide
GRILLE Ford Focus Mk3 (2011–2018) · PARTS GUIDE

Ford Focus Mk3 Grille: Fitment, Sensors & Common Damage

On adaptive-cruise Focus models, a simple grille clean is worth trying before assuming a sensor fault — plus why bumper work needs proper recalibration afterward.

Generation covered: this guide is for the third-generation Focus, built 2011–2018 (commonly the 2014–2018 registered examples still in daily use). The newer Mk4 Focus (2018–) uses different part numbers throughout — check your V5C logbook or VIN if you're unsure which generation you have.
Ford Focus Mk3 (2011-2018) radiator grille, finish chrome/black/mat, aftermarket Van Wezel 1947514 Illustration for editorial purposes
Find Ford Focus Mk3 Grille Here!

Opens live listings in a new tab.

OEM Part Number: confirm via VIN

Aftermarket parts: Van Wezel 1947514 / Diederichs 1418047

Accuracy note: Covers the Ford Focus Mk3 (2011-2018) as listed in the UK aftermarket catalogues. Grilles are sold by trim and facelift, and many generations had different grilles for base, mid and top trims, with or without a radar or camera opening. Where the catalogue splits a grille into left and right or upper and lower sections, buy both halves if both are damaged. The references below are UK aftermarket catalogue listings for this generation, labelled by brand with the fitment details the catalogue gives; carmakers rarely publish the genuine number against these, so match a genuine grille against your VIN if you want a guaranteed fit.
Radiator grille (aftermarket)Van Wezel 1947514 (chrome/black); Diederichs 1418047 (left, mat); Diederichs 1418046 (right, mat); Diederichs 1418048 (right, Titanium)
Genuine (OE) numbers quotedNone quoted in the catalogue listings — the genuine grille varies by trim level, facelift and sensor options, so order it against your VIN

The grille is one of the more visually trim-dependent parts on the Mk3 Focus — ST-Line and ST models use a different honeycomb-pattern grille to standard trims, and the 2015 facelift changed the overall front-end design significantly. A grille from the wrong trim or generation may bolt on but won't look correct, so match your existing trim level as well as generation before ordering.

With adaptive cruise, the front mesh is more than trim

If your Focus Mk3 is fitted with adaptive cruise control, the radar sensor that makes the system work sits directly behind the grille or front badge, and it's surprisingly vulnerable to something as simple as dirt, road grime, dead insects, or a build-up of ice and snow blocking its field of view. Ford's own guidance confirms a "blocked sensor" warning can appear even without a genuine obstruction, and it's worth trying a simple clean first: a soft cloth with an approved, non-abrasive cleaner (isopropyl alcohol is commonly recommended) wiped gently over the grille-mounted sensor cover, avoiding anything abrasive that could damage the cover's coating.

A grille replacement, front bumper repair, or even a minor parking knock can throw the radar sensor's alignment out — even a fraction of a degree matters, since the sensor needs to be aimed within roughly one degree of accuracy to work correctly. Any fault message referencing "sensor misaligned" or "calibration required" after this kind of work isn't something a DIY fix can properly resolve; genuine recalibration requires dealer-level diagnostic equipment, and continuing to drive with an unresolved calibration warning means the safety system may not be working as intended.

The working parts behind the Focus Mk3's badge

There's more going on behind the Ford Focus Mk3's front grille than its styling suggests: it channels air to the radiator, and on plenty of modern cars it also houses or surrounds sensors for adaptive cruise control and parking assistance. Getting the correct part means accounting for all of that, not just appearance.

Before you buy: grille design varies significantly by trim, and higher trims may integrate radar or camera sensors behind or within the grille itself. Always confirm against your VIN before ordering.
Watch: fitting it

🎬 Watch: FORD FOCUS MK3 FRONT BUMPER GRILL EMBLEM REMOVAL REPLACEMENT. GRILLE REPLACEMENT

Watch on YouTube ↗
Ford Focus Mk3 Grille reference plate

What the badge panel does for cooling on the Focus Mk3

Beyond styling, the grille on the Focus Mk3 directs airflow to the radiator and, on trims equipped with adaptive cruise control, may house or sit directly in front of the radar sensor used for that system. A grille that looks compatible but lacks the correct sensor cutout can interfere with these systems even if it fits physically.

Generations, Derivatives and Grille Finish
Standard trims (S/SE/Style/Zetec/Titanium)Matte black honeycomb mesh with a chrome moulding surround
ST-LineAll-gloss-black honeycomb mesh, different from the standard trim's chrome-trimmed version
STBlack honeycomb design continues, specific to the ST's own front bumper aperture — not interchangeable with ST-Line despite the shared black finish
Find Ford Focus Mk3 Grille Here!

Opens live listings in a new tab.

Common damage, DIY difficulty and aftermarket advice

These are the same regardless of make or model — see our full Grille Guide for common damage types, confirming trim-specific fitment, how difficult this job is to DIY, and the ADAS calibration risk with sensor-equipped grilles.

The same part on other models

The same part, covered across other Ford models.