Mercedes-Benz GLA Fuel Pump: Specs, Fitment & Common Faults
Confirmed: a safety recall addresses the low-pressure fuel pump's impeller deforming due to a manufacturing defect, causing the pump to shut down and the engine to stall suddenly while driving.
Opens live listings in a new tab.
OEM Part Number: A2464701494
As quoted in catalogue listings, confirm via VIN. Aftermarket units: Bosch 0 580 254 950 / Hüco 132737
| Fuel pumps / feed units (aftermarket) | VDO 2803580306302 (complete feed unit, petrol, with reserve sensor); Hüco 132737 (complete feed unit with sender, petrol); Hüco 132740 (complete feed unit with sender, diesel); Astemo 2502740 (complete feed unit with sender, diesel); Ridex 1382F0225 (complete feed unit with sender, diesel, 4.5 bar, 2 connectors, 12 V 10.3 A, 230 mm); Hella 8TF 358 146-301 (bare in-tank pump, 15 mm inlet, 8 mm outlet, mounting and connector parts included); Bosch 0 580 254 950 (in-line pump fitted in the fuel line); Pierburg 7.21440.51.0 (pre-supply / lift pump, 0.3-0.4 bar, 2 connectors, 133.5 mm). |
|---|---|
| Types & variants | Same W176-family tank, so petrol complete modules with sender (VDO, Hüco 132737) stand against diesel feed units with sender (Hüco 132740 / Astemo 2502740 / Ridex 1382F0225). Vemo V30-09-0162 covers the all-wheel-drive (4Matic) tank, Metzger 2250678 (7 pins) and Topran 410 537 (6 pins, swirl pot, lever sensor) are budget modules, and febi 38095 / 10576 (M16 x 1.5 thread) and DT 2.05000 are hand-primer pre-supply pumps for the diesel fuel filter. |
| Genuine (OE) numbers quoted | A2464701494 (Meat & Doria 77853); 170429F500 (Meat & Doria 76416); 8941674933 (Meat & Doria 76041, carburettor pump, not applicable). |
| Fitment notes | Order by fuel and by front or 4Matic drive. The complete modules replace the sender; only the Hella 8TF 358 146-301 is a bare pump for refitting into the original housing with the sender kept. Hüco and Astemo units carry assembly instructions, and the Ridex diesel unit is the only one quoting a pressure figure. |
Hesitation, stalling and a non-start on the GLA
On the Mercedes-Benz GLA, few component failures are as inconveniently timed as this one — it has a habit of stranding drivers mid-journey rather than giving a clean warning while the car is safely parked. Knowing the early signs buys valuable time to get it sorted before that happens.
The Mercedes-Benz GLA's fuel pump draws fuel from the tank and delivers it to the engine at the pressure required for proper combustion. Almost all modern versions sit inside the fuel tank itself, submerged in fuel, which is partly why access for replacement is more involved than the part's small size might suggest.
Which pump each engine in the GLA range uses
| All generations, M264 petrol & OM654 diesel | Spans both diesel (in-tank lift pump plus an engine-mounted high-pressure pump) and petrol (in-tank low-pressure pump, plus a separate high-pressure pump if direct-injection) variants — confirm your exact engine before ordering |
|---|
Tank-drop method, X156
Opens live listings in a new tab.
Safety recalls covering the GLA's fuel system
This is important to check directly: a confirmed recall covering many 2021-2023 models directly addresses the in-tank low-pressure fuel pump, where the pump's impeller can deform due to a manufacturing defect. Once deformed, the impeller can come into contact with its housing, creating resistance that shuts the pump down entirely and causes the engine to stall — a safety concern, since this can happen suddenly while driving. Worth checking your specific VIN against the official recall register directly, particularly on a used car where you can't be certain a previous owner had this recall work completed, since the remedy was provided free of charge.
Also, this recalled low-pressure pump is a separate component from the engine-mounted high-pressure fuel pump, located inside the fuel tank rather than on the engine itself — worth confirming which specific pump has actually failed before purchasing replacement parts.
Warning signs, DIY difficulty and aftermarket adviceThese are the same regardless of make or model — see our full Fuel Pump Guide for symptoms to watch for (including the low-pressure vs high-pressure distinction on direct-injection engines), confirming fitment against your VIN, and OE suppliers worth knowing.
The same part on other modelsThe same part, covered across other Mercedes-Benz models.