Mitsubishi Outlander Front Bumper: Fitment, Sensors & Common Damage
False parking sensor readings are often traced to moisture-related corrosion in the wiring connectors, or a sensor pushed out of alignment reading its own mounting bracket as an obstacle.
Opens live listings in a new tab.
OEM Part Number: confirm via VIN
Aftermarket covers: Prasco MB7221001 / Diederichs 5848850
| Front bumper covers (aftermarket) | Prasco MB7221001 (primed); Prasco MB7201011 (primed); Diederichs 5848850 (primed, facelift) |
|---|---|
| Splitters, outer sections & trims | None listed separately |
| Genuine (OE) numbers quoted | None quoted in the catalogue listings — the genuine cover varies by body style, trim, parking sensors and fog lights, so order it against your VIN |
| Fitment notes | Match body style, trim, facelift date and the holes for parking sensors, fog lights and washer jets; covers come primed and need painting to your paint code before fitting. |
Why repairs to the Outlander's nose add up quickly
The Mitsubishi Outlander's front bumper doubles as a sensor housing — parking sensors, adaptive cruise radar, and fog lights are all commonly built in — which is why even minor impact damage can turn a straightforward-looking swap into a bigger job.
The job the front cover does on the Outlander
Beyond absorbing minor impacts, the front bumper on higher trims of the Outlander often houses parking sensors, the radar sensor used for adaptive cruise control, and fog lights. A bumper that looks compatible can still be missing the correct cutouts or mounting provisions for your specific trim's equipment.
Watch: replacing itThis video is of an earlier generation of the same model; the job is similar but the clips and fixings can differ slightly.
| All generations | White Diamond, Black Diamond, Red Diamond, Alloy Silver, Cosmic Blue |
|---|---|
| Paint durability note | Mitsubishi's factory paint and clear coat are commonly described as unusually soft — small "pepper flake" chips on the front bumper and bonnet's leading edge are a well-documented, genuine cosmetic quirk rather than a sign of a specific fault |
Opens live listings in a new tab.
Why the Outlander sensors give false alarms
If your parking sensors keep giving false readings despite the bumper looking clean and undamaged, documented cases describe two distinct causes worth checking for. One is moisture causing corrosion within the sensor wiring connectors themselves, which can cause intermittent or false readings that come and go depending on conditions. The other is a sensor that's been pushed slightly out of alignment within the bumper cover, causing it to detect the edge of its own mounting bracket as if it were an obstacle, rather than reading anything actually near the car. Both usually require the bumper to be removed to properly inspect, clean, or reseat the sensor — worth knowing this before assuming the sensor itself is faulty and needs full replacement.
A rear valance panel replacement, supplied ready-painted in the correct colour, has been documented costing around £180 from Mitsubishi — worth using as a rough comparison point if you're getting quotes for cosmetic bumper trim damage.
Common damage, DIY difficulty and aftermarket adviceThese are the same regardless of make or model — see our full Front Bumper Guide for common damage types to check for, confirming fitment against your VIN, and the sensor-calibration risk with cheap aftermarket covers.
The same part on other modelsThe same part, covered across other Mitsubishi models.