Peugeot 108 Rear Bumper: Fitment, Sensors & Common Damage
On the 108, a free fix is worth trying before assuming the reversing camera has failed — plus a real towbar wiring part-number trap worth knowing.
Opens live listings in a new tab.
OEM Part Number: confirm via VIN
Aftermarket covers: Van Wezel 4022544 / Diederichs 4212055
| Rear bumper covers (aftermarket) | Van Wezel 4022544 (Rear, for vehicles with or without rear view camera, primed, Smooth, without holes for parking sensors, with holes for licence plate light); Diederichs 4212055 (Rear, for vehicles without parking sensors, primed); Blic 5506-00-5504950P (Rear); Klokkerholm 5500950 (Rear, primed) |
|---|---|
| Lower sections, corners & trims | None listed separately |
| Genuine (OE) numbers quoted | None quoted in the catalogue listings — the genuine cover varies by body style, parking sensors and tow bar, so order it against your VIN |
| Fitment notes | Match body style, facelift date and the holes for parking sensors or exhaust trims; covers come primed and need painting to your paint code before fitting. |
Resetting a dead camera on the 108
If your reversing camera has stopped working, showing a black screen with a warning triangle rather than the reverse view, it's worth trying a simple, free fix before assuming the camera itself needs replacing: gently prying the camera unit out of its mounting holder by hand (no tools needed), then reseating it back into the wiring loom and holder. One case resolved a "no signal" fault entirely this way, with the owner noting no actual repair was involved beyond disconnecting and reconnecting the unit — suggesting the connection had simply worked slightly loose rather than the camera or wiring being faulty.
Some cars have the physical reversing camera connector present in the wiring but disconnected or inactive from the factory, consistent with the same platform being built both with and without this feature. If you're trying to retrofit a camera, activation typically requires proper diagnostic software (DiagBox) to code the feature on, not just a physical plug-in connection.
The tech built into the back
The Peugeot 108's rear bumper routinely integrates parking sensors, a reversing camera housing and sometimes exhaust trim finishers, which means replacing it after even minor kerb damage often involves more than a straightforward swap.
Watch: replacing itThe sequence is much the same on this generation: wheel-arch liner screws, the fixings along the boot aperture and under the lower edge, then unclip each corner from the wing and unplug any sensor loom before the cover comes away.
Crash absorbers, reinforcement and the 108's back panel
Beyond absorbing minor impacts, the rear bumper on higher trims of the 108 often houses parking sensors, a reversing camera, and sometimes integrated exhaust finishers. A bumper that looks compatible can still be missing the correct cutouts or wiring provisions for your specific trim's equipment.
Generations and Colour| All generations (single generation, 2014–2021) | Bianca White, Onyx Black, Vertigo Blue, Purple Rain |
|---|
Opens live listings in a new tab.
These are the same regardless of make or model — see our full Rear Bumper Guide for common damage types, confirming fitment (body style and sensor equipment matter here), and OEM vs aftermarket guidance.
The same part on other modelsThe same part, covered across other Peugeot models.