Toyota Auris Rear Bumper: Fitment, Sensors & Common Damage
On the Auris, the factory reversing camera runs on 6V, not 12V — — check this before any aftermarket stereo work.
Opens live listings in a new tab.
OEM Part Number: confirm via VIN
Aftermarket covers: Prasco TY3541051 / Van Wezel 5315540
| Rear bumper covers (aftermarket) | Prasco TY3541051 (Rear, Colour: black, for vehicles with park assist); Prasco TY3561051 (Rear, Colour: black, for vehicles with park assist, Smooth); Van Wezel 5315540 (Rear, Smooth, with holes for trim/protective strip); Diederichs 6660055 (Rear, for vehicles without parking sensors, Smooth); Diederichs 6660155 (Rear, for vehicles without parking sensors, Smooth); Blic 5506-00-8118953P (Rear) |
|---|---|
| Lower sections, corners & trims | None listed separately |
| Genuine (OE) numbers quoted | None quoted in the catalogue listings — the genuine cover varies by body style, parking sensors and tow bar, so order it against your VIN |
| Fitment notes | Match body style, facelift date and the holes for parking sensors or exhaust trims; covers come primed and need painting to your paint code before fitting. |
Retaining the reversing camera on the Auris
If you're fitting an aftermarket stereo and trying to keep the factory reversing camera working, the factory camera runs on 6V specifically, not the standard 12V most generic wiring guides assume. One case on a related model saw a camera stay permanently on regardless of gear selected, only resolved once a proper 12V-to-6V step-down converter was correctly fitted.
Bear in mind that towbar wiring kits can be confusing to match against factory wiring colours, since generic kit instructions rarely specify which factory wire colour corresponds to which function on your specific car.
How much the back panel of the Auris carries
The Toyota Auris's rear bumper routinely integrates parking sensors, a reversing camera housing and sometimes exhaust trim finishers, which means replacing it after even minor kerb damage often involves more than a straightforward swap.
Watch: replacing itThe sequence is much the same on this generation: wheel-arch liner screws, the fixings along the boot aperture and under the lower edge, then unclip each corner from the wing and unplug any sensor loom before the cover comes away.
The tail-end structure of the Auris, explained
Beyond absorbing minor impacts, the rear bumper on higher trims of the Auris often houses parking sensors, a reversing camera, and sometimes integrated exhaust finishers. A bumper that looks compatible can still be missing the correct cutouts or wiring provisions for your specific trim's equipment.
Generations and Colour| All generations | Super White, Eclipse Black, Decuma Grey, Emotional Red |
|---|
Opens live listings in a new tab.
These are the same regardless of make or model — see our full Rear Bumper Guide for common damage types, confirming fitment (body style and sensor equipment matter here), and OEM vs aftermarket guidance.
The same part on other modelsThe same part, covered across other Toyota models.