Audi A5 Coupe Rear Shock Absorber: Specs, Fitment & Common Faults
Worth confirming first: which rear axle your A5 Coupe has, since it determines a completely different shock absorber.
Opens live listings in a new tab.
OEM Part Number: confirm via VIN
Aftermarket rear dampers: Monroe 376248SP / Sachs 318143
| Rear shock absorbers (aftermarket) | Monroe 376248SP (gas, telescopic, sport); Sachs 318143 (gas, telescopic); Sachs 318199 (gas, telescopic, sport); Meyle 1267350000 (gas, telescopic) |
|---|---|
| Genuine (OE) numbers quoted | None quoted in the catalogue listings — the genuine damper varies by engine, suspension type and body style, so order it against your VIN |
| Torsion beam axle, right | a different reference from the left-side shock — VW Group does not sell these as a single interchangeable part for either side |
| Torsion beam axle, left | A different part number from the right-side shock above |
| Multi-link axle (higher-output/4Motion variants) | a different shock from the torsion beam version — confirmed by VW Group's own workshop documentation as requiring a completely different rear damper, not a stiffer version of the same part |
| Adaptive damping shock, where fitted | A different construction from a non-adaptive shock, with a built-in electrical connector — not interchangeable with a standard shock in either direction, and fitting the wrong type will trigger a persistent dashboard warning |
On the Audi A5 Coupe, cars fitted with a vehicle level sender (part of some self-levelling or headlight self-levelling setups) have an additional linkage arm connected near the shock absorber — worth noting when removing or replacing the shock, since this arm needs to be disconnected first, but it's a separate part from the shock itself.
Beam axle or multi-link: identifying the A5 Coupe's set-up
Important to establish before ordering: VW Group's MQB-based cars use one of two different rear axle designs depending on engine and trim, and each requires a different rear shock absorber. Standard A5 Coupes with smaller petrol or diesel engines use a torsion beam (twist beam) rear axle. Higher-output and performance variants use a multi-link rear axle instead — and critically, any 4Motion/4Drive/Quattro (four-wheel-drive) variant mandatorily has multi-link regardless of engine, since a torsion beam leaves no room for a rear differential and driveshaft to pass through. If you're unsure which your car has, look underneath the rear of the car: a single, solid connecting beam is torsion beam; separate arms at each wheel is multi-link.
The quiet work the A5 Coupe's back-end dampers do
Because the Audi A5 Coupe's front suspension is tied to steering feel, it tends to get all the attention — but rear shocks wear at a similar rate, with symptoms subtle enough to be mistaken for road noise until the problem has clearly worsened.
How the A5 Coupe keeps its back wheels planted
On the Audi A5 Coupe, the rear shock absorber's role — separate from the coil spring on most modern rear axles — is managing how quickly the suspension compresses and rebounds over bumps. When it wears out, the rear end keeps bouncing rather than settling quickly, and rear tyres can wear unevenly as a result.
Opens live listings in a new tab.
These are the same regardless of make or model — see our full Rear Shock Absorber Guide for symptoms of a worn shock, confirming fitment against your VIN, and OEM vs aftermarket guidance.
The same part on other modelsThe same part, covered across other Audi models.