Audi A6 Rear Shock Absorber: Specs, Fitment & Common Faults
Worth confirming first: which rear axle your A6 has, since it determines a completely different shock absorber.
Opens live listings in a new tab.
OEM Part Number: confirm via VIN
Aftermarket rear dampers: Monroe 376025SP / Meyle 1267250036
| Rear shock absorbers (aftermarket) | Monroe 376025SP (gas, telescopic); Meyle 1267250036 (gas, telescopic); Meyle 1267250043 (gas, telescopic, sport); TRW JGT1182S (gas, telescopic, sport) |
|---|---|
| Genuine (OE) numbers quoted | None quoted in the catalogue listings — the genuine damper varies by engine, suspension type and body style, so order it against your VIN |
| Torsion beam axle, right | a different reference from the left-side shock — VW Group does not sell these as a single interchangeable part for either side |
| Torsion beam axle, left | A different part number from the right-side shock above |
| Multi-link axle (higher-output/4Motion variants) | a different shock from the torsion beam version — confirmed by VW Group's own workshop documentation as requiring a completely different rear damper, not a stiffer version of the same part |
| Adaptive damping shock, where fitted | A different construction from a non-adaptive shock, with a built-in electrical connector — not interchangeable with a standard shock in either direction, and fitting the wrong type will trigger a persistent dashboard warning |
On the Audi A6, cars fitted with a vehicle level sender (part of some self-levelling or headlight self-levelling setups) have an additional linkage arm connected near the shock absorber — worth noting when removing or replacing the shock, since this arm needs to be disconnected first, but it's a separate part from the shock itself.
Why the A6's engine and trim change the rear damper
Important to establish before ordering: VW Group's MQB-based cars use one of two different rear axle designs depending on engine and trim, and each requires a different rear shock absorber. Standard A6s with smaller petrol or diesel engines use a torsion beam (twist beam) rear axle. Higher-output and performance variants use a multi-link rear axle instead — and critically, any 4Motion/4Drive/Quattro (four-wheel-drive) variant mandatorily has multi-link regardless of engine, since a torsion beam leaves no room for a rear differential and driveshaft to pass through. If you're unsure which your car has, look underneath the rear of the car: a single, solid connecting beam is torsion beam; separate arms at each wheel is multi-link.
Bumps, loads and braking: what the A6's dampers handle
The Audi A6's front end tends to dominate suspension conversations since it steers the car, but rear shock wear happens at a comparable rate — just with subtler warning signs that often get blamed on road noise until they're too obvious to ignore.
What the dampers at the back of the A6 actually do
On the Audi A6, how quickly the rear suspension compresses and rebounds over bumps comes down to the shock absorber, a separate function from the coil spring on most modern rear axles. Wear here shows up as excessive bounce that doesn't settle quickly, and can lead to uneven rear tyre wear if left unresolved.
Opens live listings in a new tab.
These are the same regardless of make or model — see our full Rear Shock Absorber Guide for symptoms of a worn shock, confirming fitment against your VIN, and OEM vs aftermarket guidance.
The same part on other modelsThe same part, covered across other Audi models.