Skoda Kodiaq Rear Shock Absorber: Specs, Fitment & Common Faults
Genuinely worth confirming first: which rear axle your Kodiaq has, since it determines a completely different shock absorber.
Confirmed: Torsion Beam and Multi-Link Need Completely Different Rear Dampers
Genuinely important to establish before ordering: VW Group's MQB-based cars use one of two different rear axle designs depending on engine and trim, and each requires a different rear shock absorber. Standard Kodiaqs with smaller petrol or diesel engines use a torsion beam (twist beam) rear axle. Higher-output and performance variants use a multi-link rear axle instead — and critically, any 4Motion/4Drive/Quattro (four-wheel-drive) variant mandatorily has multi-link regardless of engine, since a torsion beam leaves no room for a rear differential and driveshaft to pass through. If you're unsure which your car has, look underneath the rear of the car: a single, solid connecting beam is torsion beam; separate arms at each wheel is multi-link.
The Part That Takes Every Bump Before You Feel It
Front suspension tends to get most of the attention since it also handles steering, but the rear shock absorbers wear too — often more subtly, with symptoms that are easy to write off as road noise until they get worse.
OEM Part Numbers
| Torsion beam axle, right | Genuinely a different reference from the left-side shock — VW Group does not sell these as a single interchangeable part for either side |
|---|---|
| Torsion beam axle, left | A genuinely different part number from the right-side shock above |
| Multi-link axle (higher-output/4Motion variants) | Genuinely a different shock from the torsion beam version — confirmed by VW Group's own workshop documentation as requiring a completely different rear damper, not a stiffer version of the same part |
| Adaptive damping shock, where fitted | A genuinely different construction from a non-adaptive shock, with a built-in electrical connector — not interchangeable with a standard shock in either direction, and fitting the wrong type will trigger a persistent dashboard warning |
Cars fitted with a vehicle level sender (part of some self-levelling or headlight self-levelling setups) have an additional linkage arm connected near the shock absorber — genuinely worth noting when removing or replacing the shock, since this arm needs to be disconnected first, but it's a separate part from the shock itself.
What It Does
The rear shock absorber controls how quickly the rear suspension compresses and rebounds over bumps, working independently of the coil spring on most modern rear axles. A worn rear shock lets the back of the car bounce excessively after a bump instead of settling quickly, and can accelerate uneven rear tyre wear if left unaddressed.
Shop for This Part on eBay
Skoda Kodiaq Rear Shock Absorber 2.0 TSi 4x4 Petrol 195kW (265 HP) 5QS512037BG
GBP 90.73
SHOCK ABSORBER REAR RIGHT DRIVER SIDE 2.0 DIESEL 5QS513049L SKODA KODIAQ MK2
GBP 44.00
SKODA KODIAQ SUSPENSION SHOCK ABSORBER REAR PAIR 2021-2024 5QF513049CB
GBP 36.00
SKODA KODIAQ SUSPENSION SHOCK ABSORBER REAR MK1 NS 2021-2024 5QF513049CB
GBP 36.00
Skoda Kodiaq VW Tiguan 19 2.0 TDI 4 Motion Rear Shock Absorber Pair 5QF513049CC
GBP 59.90
Skoda Kodiaq NS7 Rear Shock Absorber 2016-on 3Q0513049FT Genuine NEW OEM
GBP 50.99
SKODA KODIAQ SUSPENSION SHOCK ABSORBER REAR PAIR 5QF513049CB MK1 2021-2024
GBP 36.00
Skoda Kodiaq 2017 rear shock absorber damper 5QF512009C MKO479165
GBP 208.99
As an eBay Partner, CarUnited may earn commission from qualifying purchases shown above. Listings and pricing are pulled live from eBay and may vary.
Warning Signs, DIY Difficulty & Aftermarket Advice
These are the same regardless of make or model — see our full Rear Shock Absorber Guide for symptoms of a worn shock, confirming fitment against your VIN, and OEM vs aftermarket guidance.
More Skoda Rear Shock Absorber
The same part, covered across other Skoda models.