Skoda Superb Rear Shock Absorber: Specs, Fitment & Common Faults
Worth confirming first: which rear axle your Superb has, since it determines a completely different shock absorber.
Opens live listings in a new tab.
OEM Part Number: confirm via VIN
Aftermarket rear dampers: Monroe 376246SP / Meyle 1267250017
| Rear shock absorbers (aftermarket) | Monroe 376246SP (gas, telescopic, sport); Meyle 1267250017 (gas, telescopic); Vaico V10-7844 (gas, telescopic, sport) |
|---|---|
| Genuine (OE) numbers quoted | None quoted in the catalogue listings — the genuine damper varies by engine, suspension type and body style, so order it against your VIN |
| Torsion beam axle, right | a different reference from the left-side shock — VW Group does not sell these as a single interchangeable part for either side |
| Torsion beam axle, left | A different part number from the right-side shock above |
| Multi-link axle (higher-output/4Motion variants) | a different shock from the torsion beam version — confirmed by VW Group's own workshop documentation as requiring a completely different rear damper, not a stiffer version of the same part |
| Adaptive damping shock, where fitted | A different construction from a non-adaptive shock, with a built-in electrical connector — not interchangeable with a standard shock in either direction, and fitting the wrong type will trigger a persistent dashboard warning |
On the Skoda Superb, cars fitted with a vehicle level sender (part of some self-levelling or headlight self-levelling setups) have an additional linkage arm connected near the shock absorber — worth noting when removing or replacing the shock, since this arm needs to be disconnected first, but it's a separate part from the shock itself.
How the Superb's axle type affects which damper fits
Important to establish before ordering: VW Group's MQB-based cars use one of two different rear axle designs depending on engine and trim, and each requires a different rear shock absorber. Standard Superbs with smaller petrol or diesel engines use a torsion beam (twist beam) rear axle. Higher-output and performance variants use a multi-link rear axle instead — and critically, any 4Motion/4Drive/Quattro (four-wheel-drive) variant mandatorily has multi-link regardless of engine, since a torsion beam leaves no room for a rear differential and driveshaft to pass through. If you're unsure which your car has, look underneath the rear of the car: a single, solid connecting beam is torsion beam; separate arms at each wheel is multi-link.
How a loaded boot tests the Superb's dampers
It's easy to focus entirely on the Skoda Superb's front suspension, since it also does the steering, but the rear shocks age just the same — often with subtler symptoms that get dismissed as road noise right up until they can't be ignored.
Why the Superb needs dampers as well as springs
On the Skoda Superb, controlling the speed of rear suspension compression and rebound over bumps is the shock absorber's job, working separately from the coil spring on most current rear axle designs. A worn one means the back end bounces longer than it should after a bump, and rear tyre wear often turns uneven if it's left unaddressed.
Opens live listings in a new tab.
These are the same regardless of make or model — see our full Rear Shock Absorber Guide for symptoms of a worn shock, confirming fitment against your VIN, and OEM vs aftermarket guidance.
The same part on other modelsThe same part, covered across other Skoda models.