Skoda Yeti Rear Shock Absorber: Specs, Fitment & Common Faults
Worth confirming first: which rear axle your Yeti has, since it determines a completely different shock absorber.
Opens live listings in a new tab.
OEM Part Number: confirm via VIN
Aftermarket rear dampers: Monroe G1057 / Febi Bilstein 1002279
| Rear shock absorbers (aftermarket) | Monroe G1057 (gas, telescopic); Febi Bilstein 1002279 (gas, telescopic); Febi Bilstein 1002873 (gas, telescopic, heavy duty) |
|---|---|
| Genuine (OE) numbers quoted | None quoted in the catalogue listings — the genuine damper varies by engine, suspension type and body style, so order it against your VIN |
| Torsion beam axle, right | a different reference from the left-side shock — VW Group does not sell these as a single interchangeable part for either side |
| Torsion beam axle, left | A different part number from the right-side shock above |
| Multi-link axle (higher-output/4Motion variants) | a different shock from the torsion beam version — confirmed by VW Group's own workshop documentation as requiring a completely different rear damper, not a stiffer version of the same part |
| Adaptive damping shock, where fitted | A different construction from a non-adaptive shock, with a built-in electrical connector — not interchangeable with a standard shock in either direction, and fitting the wrong type will trigger a persistent dashboard warning |
On the Skoda Yeti, cars fitted with a vehicle level sender (part of some self-levelling or headlight self-levelling setups) have an additional linkage arm connected near the shock absorber — worth noting when removing or replacing the shock, since this arm needs to be disconnected first, but it's a separate part from the shock itself.
Why the Yeti's engine and trim change the rear damper
Important to establish before ordering: VW Group's MQB-based cars use one of two different rear axle designs depending on engine and trim, and each requires a different rear shock absorber. Standard Yetis with smaller petrol or diesel engines use a torsion beam (twist beam) rear axle. Higher-output and performance variants use a multi-link rear axle instead — and critically, any 4Motion/4Drive/Quattro (four-wheel-drive) variant mandatorily has multi-link regardless of engine, since a torsion beam leaves no room for a rear differential and driveshaft to pass through. If you're unsure which your car has, look underneath the rear of the car: a single, solid connecting beam is torsion beam; separate arms at each wheel is multi-link.
How a loaded boot tests the Yeti's dampers
On the Skoda Yeti, steering duties mean the front suspension usually gets checked first, but rear shocks wear out too — just more quietly, with early symptoms that are easy to mistake for ordinary road noise until they get noticeably worse.
This video shows a closely related car on the same platform, so the mounts and fixings can differ slightly on yours.
How the Yeti keeps its back wheels planted
Independently of the coil spring on most modern rear axles, the Skoda Yeti's rear shock absorber governs how fast the rear suspension compresses and rebounds over bumps. Once worn, it lets the back of the car keep bouncing after a bump rather than settling promptly, and can speed up uneven rear tyre wear if ignored.
Opens live listings in a new tab.
These are the same regardless of make or model — see our full Rear Shock Absorber Guide for symptoms of a worn shock, confirming fitment against your VIN, and OEM vs aftermarket guidance.
The same part on other modelsThe same part, covered across other Skoda models.