Hyundai i30 Radiator: Specs, Fitment & Common Faults
On the i30, a leak from the weep hole near the A/C compressor points toward a failing water pump seal.
Opens live listings in a new tab.
OEM Part Number: 25310G4300
As quoted in catalogue listings, confirm via VIN. Aftermarket units: Nissens 636728 / Denso DRM43023
| Radiators (aftermarket) | Nissens 636728 (648 x 291 x 26 mm, aluminium core with plastic tanks, fits 1.0 T-GDi G3LC/G3LE, 1.4 T-GDi G4LD, 1.5 DPI G4LG and 1.5 T-GDi 48V G4LK); Nissens 606739 (648 x 291 x 26 mm, aluminium core with plastic tanks, fits 1.6 CRDi D4FB 95/110/128/136); Denso DRM43023; Mahle CR 1975 000P; Van Wezel 82012734 (petrol) and 82012735 (diesel); NRF 550034 (diesel). |
|---|---|
| Core sizes & variants | Petrol and diesel radiators are the same size with 35 mm connections but carry different part numbers; the petrol unit (OE 25310G4300 / 25310F3300 / 25310J7800) is shared with the Kia Ceed CD, Proceed and XCeed, and the diesel unit (OE 25310F2200) is shared with the Elantra AD 1.6 D. |
| Genuine (OE) numbers quoted | 25310G4300; 25310F3300; 25310J7800; 25310F2200 |
| Fitment notes | Both radiators are supplied with gaskets and seals. Order by fuel type rather than by dimensions, since the two cores measure the same. |
A diagnostic detail for coolant leaks on the i30
If you're trying to pin down exactly where a coolant leak is coming from, a leak from the small weep hole in the engine block near the A/C compressor points toward a failing water pump seal rather than a more general leak elsewhere.
Bear in mind that the thermostat housing sits toward the front of the engine, higher up than where normal AC condensation would appear — worth checking this specific area if you're unsure whether water underneath the car is genuine coolant or harmless condensation.
Keeping the i30's engine at the right temperature
It's an unglamorous part, but on the Hyundai i30, the cooling system is behind almost every serious non-wear engine failure that could have been prevented. Spotting trouble here early is about as cheap an insurance policy as exists against an expensive repair bill.
Watch: replacing itAutodoc video on the i30 CW estate (pre-2017); nothing found on the PD generation
Why the i30 runs a pressurised cooling system
On the Hyundai i30, heat from the engine coolant is shed to the surrounding air through the radiator, keeping engine temperature in a safe range. On automatic gearboxes, it often doubles up, cooling transmission fluid through a separate internal circuit too — which is why getting the exact part number right matters more here than on a simple heat exchanger.
Opens live listings in a new tab.
These are the same regardless of make or model — see our full Radiator Guide for the three common failure modes, confirming fitment against your VIN, and OEM vs aftermarket guidance.
The same part on other modelsThe same part, covered across other Hyundai models.